SEARCH
TOOLBOX
LANGUAGES
Foundry

Foundry

From GarrettHoneycutt

Jump to: navigation, search

Contents

Common commands for Foundry switches and load balancers

General Commands

  • show run - shows the current (running) configuration
  • show config - shows the saved (startup) configuration
  • show int bri - quick status of all interfaces
  • show int eth 18 - detailed information on interface ethernet 18
  • show vlan - shows VLAN information and port association
  • show log - shows the log
  • show mac-address - shows the mac addresses
  • exit - leave the current mode


Configuration commands

  • enable - needed to make changes
  • conf t - go from exec to configuration mode
  • int eth 18 - go into interface editing mode for ethernet 18
    • port-name - set port name for a port
    • no port-name - erase the port's name
    • enable - enable the interface
    • disable - disable the interface
  • vlan 902 - go into vlan editing mode for vlan 902
    • untag eth 18 - add interface 18 to this vlan as an untagged port
    • tag eth 18 - add interface 18 to this vlan as a tagged port
    • no untag eth 18 - remove interface 18 from this vlan when it was an untagged port
  • write mem - write the current configuration to flash

Creating a VLAN

  • vlan <vlan #> name <name of vlan> by port
  • # vlan 666 name cursed-vlan by port

Adding ports to a VLAN

  • First edit the vlan, with vlan 666
  • (config-vlan-666)#untagged ethe 25 to 28 - this would add ports 25 through 28 inclusive to vlan numbered 666

Misc things

  • grep
| include

example to ouput lines in the config containing "mail". Note this doesn't seem to be available in older code versions.

 sh run | include mail
  • find which vlan's your port is using
show vlan eth X

Load balancer commands

  • show server real - shows state and stats of real servers
  • show server virtual - shows state and stats of virtual servers
  • show server - shows quick status of all virtual and real servers

Load balancer configuration

  • server real host1 - go into real server editing mode for real server host1
    • port smtp - add smtp port on this host
    • port smtp disable - remove smtp port from this host
  • server virtual virtualhost - go into virtual server editing mode for virtual server virtualhost
    • bind smtp host1 smtp - bind the smtp port on real host host1 to this virtual server
    • no bind smtp host1 smtp - unbind the smtp port on real host host1 from this virtual server

Deleting servers and virtual servers

  • no server real foo - deletes server foo
  • no server virtual foo - deletes VIP foo

Example load balancer configuration

First add the real hosts. We'll use real hosts mailhost1 and mailhost2 and a proto of smtp in this example:

server real mailhost1 1.2.3.3
 port default disable
 port smtp
 port smtp keepalive

server real mailhost2 1.2.3.4
 port default disable
 port smtp
 port smtp keepalive

Then add the virtual host(s):

server virtual mailhost 1.2.3.5
 predictor least-conn
 port default disable
 port smtp
 bind smtp mailhost1 smtp mailhost2 smtp

This creates a virtual server called mailhost listening on IP address 1.2.3.5. The VIP listens on the SMTP port and passes SMTP traffic to the real servers, mailhost1 and mailhost2.